How do they clean old buildings to make them look new?

One of the most effective ways in cleaning old buildings and make them look new is by using a pressure washer. This also helps finish the job in less than half the time. The good thing about using pressure washer is that it easily removes grime and mildew from the exterior of wall surfaces. It allows water to be powerful enough to easily clean dirt from buildings. Aside from removing dust and dirt, pressure washers are also used to peel off loose paint for the exteriors. This is perfect in preparing the building for repainting.

Before using the pressure washer

As the term implies, there’s too much pressure in this machine. Therefore, you should not play with it. Pointing it to the direction of humans or pets can cause severe pain or even injuries. It is also important to note that the hose might be difficult to control due to the amount of pressure coming out of it. Therefore, you have to stay in control of it. It also helps if you read the manuals for instructions on how to use the power washer, especially if it is your first time to use it.

Preparing the area for cleaning

Before you start using the pressure washer, you have to remove covers or other potential hazards first. All other items that could be hit must be removed. Furniture, plants, ornaments and other items should not be in the area. All windows and doors of the buildings must be closed. Those who are not involved in the process must also be asked to stay away.

For the person using the power washer, it is a must to wear protective gear. A mask and safety gloves would be necessary. Safety must be the priority.

Cleaning up the building

The key in cleaning up the building is to point the washer in bottoms up direction. The pressure spray must also be a detergent solution. Once the area is covered with the detergent solution, let it stay there for a while. It helps if the solution gradually removes the dust and dirt. After a few minutes, you can hose the surface off using plain water.

In using the power washer, it should be done from side to side to ensure that no area is left uncovered. It is also advised to spray the water at a certain angle and not just straight up or down. Otherwise, it will bounce back and it would be a mess. If there are areas that are still dirty after using the washer, you can scrub it off.

Important tips

Before using the power washer, it helps if you loosen the direct with low-pressure spray. By the time you are to use the power washer, it becomes a lot easier to get things done. It is also advised to use hot water instead of cold water when cleaning. It is more effective in cleaning up old buildings with less detergent applied. Most of all, it is important that the wall is rinsed off before it dries. Otherwise, you would have to repeat the entire process.

You should buy a power washer now

If power washers can be effectively used in cleaning up old buildings, they are also perfect for use at home. They can clean walls, cars and dirty floors. The good thing about power washers is that they can easily remove stain from the surface. You won’t have to spend several hours just to get the job done. You also use less chemical which could be detrimental. The washer alone is already enough. Most of all, the amount of time you spend for scrubbing and scraping will be reduced drastically. If you are in a hurry or you have other chores to finish, it helps a lot. You won’t dread cleaning time anymore if you have this reliable partner.

You don’t have to worry if you can’t find pressure washers in your local area. You can check out the best pressure washer 2017  reviews online. Once you have found the perfect equipment, you can start using it at home. Again, it is important to understand how it is properly used and for safety measures to be observed during the process.

Also see: Our Top 5 Items to Buy for Your Garden in 2017